大学英语词汇短语释义解析及例句 stress concentration
释义：
stress concentration [力] 应力集中
例句：
Force sensor design principle of the stress concentration.
测力传感器设计的应力集中原则。
Big distortion and stress concentration happened near the tip of crack.
裂纹尖端附近有较大变形，应力集中明显。
The stress concentration may be reduced if adopting circular arc transition.
采用圆弧过渡可以降低应力集中现象。
The stress concentration caused by the corrosion pit was numerically analyzed.
分析了锈蚀坑存在造成钢筋应力分布变化的规律。
The expression for calculating dynamic stress concentration factor is presented.
给出了动应力集中系数的计算表达式。
The expressions for calculating the dynamic stress concentration factors are given.
给出了界面处动应力集中系数的表达式。
The stress concentration factor of cylinder is much larger than that of other three kinds.
圆柱形颗粒的应力集中在基体达到屈服后要远远高于其他三种颗粒。
The Phenomena of stress concentration of tubular T joints are investigated widely in this paper.
本文对T型管状接头的应力集中现象进行了广泛的研究。
And the paper shows a reasonable connecting form by comparing stress concentration coefficients.
通过对应力集中系数的比较，提出了较为合理的连接形式。
Finite element analysis shows that there are three stress concentration areas inside the bearing.
有限元分析表明，轴承内部存在三个应力集中区域。
Increased hanging area and weighting of main roof caused abutment stress concentration and stress transfer.
由于悬露面积增大或老顶来压引起支承压力集中和转移。
Stress concentration caused by chamber's excavation engenders tensile and compressive stress to surrounding rock.
洞室开挖会使围岩周边产生应力集中，产生拉应力与压应力。
Because of the continuous energy accumulation of stress concentration units, hardening process of medium emerges.
应力集中单元由于能量的不断积累，介质出现硬化过程。
Produced stress concentration if weld reinforcement too large for submerged arc welding, so it should be control.
埋弧自动焊焊缝余高过大会对压力容器产生应力集中的影响，因此应加以控制。
All stress concentration factors so far presented in this book discussed the geometric or full theoretical values.
本书内所提到的全部应力集中系数都是几何的或纯理论值。
The research shows that the stress concentration is large near the interface of each component in the area of node.
研究表明，节点区域内各构件的接触面附近，存在较大的应力集中现象。
Conclusion: the main reason of refracture through the last screw hole in plate fixation is over-stress concentration.
结论钢板边缘末位螺丝钉孔处再骨折的发生，主要与钢板两端应力集中有关。
The soft joint can suit to the nonuniform settlement of foundation and decrease stress concentration at connection part.
软接头能较好适应地基不均匀沉陷，减小心墙和防渗墙结合部的应力集中。
In this paper, by considering the contact between hollow slab and rubber bearing to study the stress concentration issue.
本文通过考虑橡胶支座与板端底面之间的接触问题来研究板端应力集中现象。
Plating into a transition (radius transition or undercut) will create a stress concentration that can cause crack initiation.
如果过渡段被电镀(倒角和内切槽)将会产生应力集中，造成裂纹。
Coefficients of dynamic stress concentration change with lining aperture, thickness of lining, wave number and type of lining.
介质和衬砌内动应力集中系数随孔径、衬砌厚度、波数变化而变化，且与衬砌性质有关。
