To use a 3M 314 self-stripping electrical connector, follow these steps:

Preparation: Ensure the wires to be connected are clean and free of damage.
Insert Wires: Push the stripped ends of the wires into the connector until they reach the stop.
Crimp: Squeeze the connector firmly with your fingers or a tool, if necessary. This will strip the insulation and create a connection.
Check Connection: Gently pull on the wires to ensure a secure fit.
Insulate: If needed, cover the connector with electrical tape or a heat shrink tube for added protection.

Always follow manufacturer instructions for best results. You can check our Installation Video on TAEPo's Official website: www.taepo.com.